3G TX-3G01 User Manual page 11

4) Set MMS phone numbers: The 3G system will send MMS with pictures to the pre-setting
MMS phone number when alarm happen. You can input the MMS phone number as
above interface show you.
After setting, please click
4.6 Click
This 3G alarm system can match 32pcs alarm accessories totally (PIR-Door sensor-water
detector-gas detector-smoke detector-heat detector,etc.) and up to 5pcs remote controllers.
As above interface shows you, when you program new sensors into 3G system, you should
do it like this:
choose Accessory
system  3G system send out two BEEPs indicates programing OK.
NOTE:
1) We usually program wireless sensors as above interface shows you:
a. Remote control  Emergency mode  01
b. PIR  Bypass mode  02 (Bypass mode, then you can disarm PIR sensors seperately)
c. Door sensor  Arm mode  03
2) Check alarm accessories, showing as below:
to save all the settings.
to program wireless sensors:
name  choose alarm
 Trigger the wireless sensor to send a signal to 3G
Mode  choose Zone number  Click
11