Advertisement
3
rd
step: Prepare 1pcs W-CDMA SIM card which can be dialed out(pre-charge), insert it into
"SIM Card" slot parallelly. If it needs to connect siren, please plug it into "Siren" slot, if it need
recording, please insert TF Flash card into "TF-Flash" slot, then plug the adapter into "Power"
slot, the main host will make one sound "Beep", built-in PTZ will rotate left-right, enter main
host self-checking status.
4th step: After a while, the main host will make "Beep" continuous sound again,after B sound
finished, it means the main host initialization finished and enter normally standby status. At
this time, the "Network" LED light flash 1 time/second about, it means finding 3G signal
successfully.
Network light working instruction:
a. If the network light is normal on, it indicates no 3G signal or no 3G WCDMA SIM card.
b. If the network light flashes every 1s, it indicates there is GSM signal or 3G signal.
State light working instruction:
a.If state light is normal on, it indicates the main panel is armed.
b.If state light is normal off, it indicates the main panel is disarmed.
c.If state light flashes quickly, it indicates the main panel is alarming.
Main host built-in buzzer indicating instruction:
A. The main panel will make "beep" sound 1 time/s, it means the main host is searching
network and initialization.
B. The main panel will make"beep"sound if you press every key of the remote controller.
C. When using wireless controller to operate the main host, after input the command, the
main host will send out a long "beep" sound, it indicates operation is successful. If main host
makes "beep" for 3 times, it means inputs is wrong or the setting is failed(wrong password).
Back-up battery using instruction: (You can choose one of them before factory)
1)
A.When the SIM card is inserted correctly, it will turn on the built-in battery to support the
main host working.
B.When the SIM card is pulled out, it will turn off the built-in battery.
C.Please pull the SIM card out, then insert it again if you want the main host restart.
2)When Figure 2(12) Power plug is plug out, the built-in battery doesn't work to supply power.
When Figure 2(10) power adapter or Figure 2(11) Connector of Extension Cable is taken out,
or AC power is failure, the built-in battery can continue to work.
IR day/night light working instruction:
When the light is in dark, the Infrared night-vision lamp will work automatically.
SIM card/T-Flash card insert & pop out instruction:
Insert: Insert SIM card or TF card parally into "SIM Card" slot or "T-Flash card", push it to the
5
Advertisement
