Sharp XV-Z201E Operation Manual page 59

6
Insert the ne
Press the lamp
unit compartm
ing screws.
Info
If the temperatu
sible solutions o
plugging in the
If the power is t
projector, and th
the lamp may no
AC outlet and th
If you want to c
mode. After the
The cooling fan
automatically. T
7
and this is not a Attach the lamp unit cover.
Regardin
Do not unplug t
Slide the lamp unit cover in the direc- Appendix
running. The co
tion of the arrow.
Fasten the user service screw.
Lamp
Resetting the Lamp
Timer
It is recommended that the lamp (sold separately) be replaced when the remaining lamp life be-
Reset the lamp timer after replacing the lamp.
comes 5% or less, or when you notice a significant deterioration in the picture and color quality.
The lamp life (percentage) can be checked with the on-screen display. See page 51.
1
Plug the power cord.
For lamp replacement, please consult your nearest Sharp Authorised Projector Dealer or Service Centre.
Confirm that the POWER indicator il-
Caution Concerning the Lamp
luminates red.
This projector utilizes a pressurized mercury lamp. A loud sound may indicate lamp failure. Lamp
failure can be attributed to numerous sources such as: excessive shock, improper cooling, surface
scratches or deterioration of the lamp due to a lapse of usage time. The period of time up to failure
largely varies depending on the individual lamp and/or the condition and the frequency of use. It is
important to note that failure can often result in the bulb cracking.
When the lamp replacement indicator and on-screen display icon are illuminated, it is recommended
that the lamp be replaced with a new one immediately, even if the lamp appears to be operating
normally.
Should the lamp break, the glass particles may spread inside the lamp unit or gas contained in the
lamp may be vented into the room from the exhaust vent. Because the gas in this lamp includes
mercury, ventilate the room well if the lamp breaks and avoid all exposure to the released gas. In
2
case of exposure to the gas, consult a doctor as soon as possible.
Reset the lamp timer.
Should the lamp break, there is also a possibility that glass particles may spread inside of the
projector. In such a case, it is recommended you contact your nearest Sharp Authorised Projector
Press
Dealer or Service Centre to remove the damaged lamp and assure safe operation.
in order. Then press
Replacing the Lamp
"LAMP 0000H" is displayed on the
screen.
Caution
Info
Do not remove the lamp unit immediately after operation of the projector. The lamp will be hot and touching
it can lead to burn or injury.
Make sure to reset the lamp timer only
Wait at least one hour after the power cord is disconnected to allow the surface of the lamp unit to fully cool
when replacing the lamp. If you reset the
before removing the lamp unit.
lamp timer and continue to use the same
lamp, the lamp may become damaged or
If the new lamp does not light after replacement, take your projector to the nearest Sharp Authorised
explode.
Projector Dealer or Service Centre for repair. Purchase a replacement lamp unit of type BQC-
XVZ200++1 from your nearest Sharp Authorised Projector Dealer or Service Centre. Then carefully
change the lamp by following the instructions described in this section. If you wish, you may have
the lamp replaced at your nearest Sharp Authorised Projector Dealer or Service Centre.
Downloaded From projector-manual.com Sharp Manuals
, , , , and
.
UNDO button
Power cord
ON button
INPUT button
ENTER button
-6