SafeCom SWSIP-1000 User Manual page 58

WLAN SIP IP Phone
b. Warning Messages
Warning messages are displayed when the phone detects a condition that may disrupt
your phone service.
12:00
SWSIP-1000
Net Fail! (DHCP)
Menu Names
12:00
SWSIP-1000
Not Registered
Menu Names
. Site Survey
AP1 99 W
Copyright © 2006 Safecom Technologies Limited
Warning 1: No display when the phone is seated in the
charger.
- Situation 1: The phone is seated in the charger but there is
no LCD display and back light, even if it has been powered on.
- Situation 2: The phone is seated in the charger but there is
no LCD display; the back light is on.
Corrective Action:
Place the phone in the charger and turn off the power. Keep
the phone in the charger for approximately 30 seconds. Then
remove it from the charger briefly, for approximately 2
seconds. Place the phone back in the charger and it will
automatically turn on.
Warning 2: Battery Low (
The battery energy level is low.
Corrective Action: Recharge the battery
Warning 3: Weak signal detected ( blinking)
The signal quality is low.
Corrective Action:
Connect to another AP. Move your phone closer to the AP.
There may be too much radio interference (for example a
microwave or another AP using the same channel) around
your wireless network. Relocate or reduce the radio
interference.
www.safecom.cn
SWSIP-1000 User Manual
blinking)
.
54