SafeCom SWSIP-1000 User Manual page 45

WLAN SIP IP Phone
LABEL DESCRIPTION
Click STATIC to manually enter a fixed IP address.
Get IP
Click DHCP to have the SWSIP-1000 automatically obtain network settings from a Dynamic
Address
Network Host Configuration Protocol server. These settings are configurable.
Mode Click PPPoE if your ISP uses Point-to-Point Protocol over Ethernet.
Network IP This is the IP address your SWSIP-1000 uses to connect to the wireless LAN. Type the
address given to you by your network administrator.
Network The subnet mask specifies the network number portion of an IP address. Type the
Subnet subnet mask given to you by your network administrator.
Mask
Default Type the gateway IP address of the device to which you want to connect your
Gateway SWSIP-1000.
MAC Every Ethernet device has a unique MAC (Media Access Control) address. The
Address MAC address is assigned at the factory and consists of six pairs of hexadecimal
characters, for example, 00:A0:C5:00:00:02.
This field is read only and cannot be configured.
DNS Server Type the DNS' IP address for translating readable domain names into valid
IP computer IP addresses.
Second DNS Type a backup DNS IP address for the SWSIP-1000 to use in the event that the
Server IP SWSIP-1000 cannot connect to the preferred DNS.
APPLY Click APPLY to save your changes without restarting the SWSIP-1000. Your wireless
LAN, Internet and SIP settings changes do not take affect until you use RESTART
(in the navigation panel).
CANCEL Click CANCEL to begin configuring this screen afresh.
Copyright © 2006 Safecom Technologies Limited
www.safecom.cn
SWSIP-1000 User Manual
41