Symbology Settings Table - CipherLab 8000 Series User Manual

SYMBOLOGY SETTINGS TABLE

The symbology settings for the LR/ELR scan engine are all supported on the 2D scan engine. In
addition, the 2D scan engine supports the following symbology settings:
2D
Code 11
Verify Checksum
Transmit Checksum
Select Length
Postal Codes
US Postnet
US Planet
Transmit US Postal
Checksum
UK Postal
Transmit UK Postal
Checksum
Japan Postal
Australian Postal
Dutch Postal
Composite Codes
Composite CC-C
Composite CC-A/B
Composite TLC-39
GS1 Code 128
Emulation Mode
Description
Decide whether to verify the checksum. If the checksum is
incorrect, the barcode will not be accepted.
No verification
One Check Digit
Two Check Digits
Decide whether to include the checksum in the data being
transmitted.
"Verify Checksum" must be enabled so that the
checksum can be left out (= "Transmit Checksum"
disabled).
Any Length
One or two fixed lengths
Range (1~55)
US Postnet or US Planet must be enabled first!
UK Postal must be enabled first!
Transmit data as if it was encoded in Code 128 barcodes.
Transmit AIM Code Identifier must be enabled first!
Appendix IV 2D Scan Engine
Default
Enable
No
No
4~55
---
Enable
Enable
Enable
Enable
Enable
Enable
Enable
Enable
---
Enable
Disable
Disable
Disable
115