After the display fully ejects, rotate the display to view the LEDs.
2.
Release the full-length expansion board retainer
To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 28).
o
Remove the server from the rack (on page 28).
o
Remove the access panel
4.
("Access
panel" on page 32).
Removal and replacement procedures 30