If Paint Is Used; Plastic Mold Tooling; Plastics Flammability; Texture/Glossing Of House - Philips 227E3QPHSU/27 Service Manual

Meridian 3
92

5.9 If paint is used

RoHS required
WEEE require
If new painting type needs to implement, refer to UN-D 1235.

5.10 Plastic mold tooling

Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines,
gate marks, ejector marks, etc.). Refer to "TYV61-90007".
Painting to cover up cosmetic defects due to molding is strongly discouraged.
China RoHS mark requested.

5.11 Plastics flammability

All Plastics to be Flame Retardant UL 94-HB or better.
Base / Rear to be Flame Retardant UL 94-HB.
All major plastic parts (bezel, back cover) need to be molded from same resin.
Plastic resin type selection should be referred to "plastic-Philips Pool monitor".
5.12 Texture/Glossing of housing
The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to "UN-D249", "UN-D 600".
>= 80 gloss units

5.13 Tilt and swivel base

Tilt angle:
Swivel Angle
High Adjustment
Portrait Display

5.14 Kensington Lock

Must meet Kensington_slot.spec "TYE-M0004".
MMD request metal plate in Kensington hole.

5.15 Label

Regulatory label / Carton label should follow Philips requirement.
Detail document refer to Philips Engineering Reference Book.
5.16 Product dimension / Weight (Refer to Philips approved SHT 191/ SHT560)
Unit dimension
Packed unit dimension:
Net weight
Gross weight
-5 +2/- 0 (forward)
+20 + 3/- 0 (backward)
nil
nil
nil
: