Philips 227E3QPHSU/27 Service Manual page 48

Meridian 3
48
8. Programing success. There will be the message in the red frame after successful programming.
12.4 Check the firmware version and reset the factory setting
Check the firmware version
1. Connect the video source and power off the monitor.
2. Press and buttons at the same time, power on the monitor, and then press the menu again; the
picture will appear on the top left corner.
3. Select the "Factory" and press the "MENU" button to enter the factory mode.
4. Please do "Auto Color" in factory menu after change main board and upgrade F/W.
5. Power off to exit the factory mode.