Vbrick 9000 Series Reference; Device Interfaces; Video-In; Audio-In - VBrick 9000 Getting Started Manual

VBrick 9000 Series Reference

Device Interfaces

Video-In

Table 1. Support Video Inputs
Interface
Component
Composite
HDMI
SDI
VGA

Audio-In

Each channel on the encoder can accept digital audio via the HDMI port (
analog audio using the A/V breakout cable (
Multimedia Interface) carries high-quality multichannel audio. It moves the audio across the
TMDS lanes using a packet structure. The audio can be sampled at rates of 32, 44.1, or 48
KHz.
Table 1. Supported Digital Audio Formats
Format
HDMI
SDI

COM 1/COM 2

RS-232/422/485 COM Port Pinouts
The encoder has two COM ports. COM 1 is generally used for management (9600 8N1)
although it can also be used for passthrough; COM 2 is used for passthrough. When COM1
Passthrough is enabled, the management port and CLI are not available. The COM
Passthrough Port is used to pass control information between VBrick encoders over the
network. The
COM
Encoder Admin Guide
Description
The component connectors (
definition video and audio.
The yellow jack with an RCA connector is used for composite video
input.
The (High-Definition Multimedia Interface) connector supports
HDMI
both digital audio and video.
The Serial Digital Interface supports both SD-SDI typically used for
broadcast-grade video (meets SMPTE 259M) or HD/3G-SDI which
processes 1080p at bit rates of 2.97 Gbits/sec (meets SMPTE 424M)
and digital audio.
The Video Graphics Array connectors support most of the common
analog output videos from a PC or laptop.
Description
HDMI 1.1 compatible audio interface (basic audio).
User selected digital audio stereo channel 1, 2, 3, or 4.
port presents a standard DTE interface on an RJ-45 connector. The serial
Chapter 11
) on the A/V cable support high
YPbPr
). The HDMI port (High Definition
Unbalanced
) or
Digital L+R 1/2
57