Front Panel Lcd Display Messages - VBrick 9000 Getting Started Manual

Step 4: Find or Set an IP Address
Step 5: Verify Streaming Video and Audio

Front Panel LCD Display Messages

The encoder (and blade) has a read-only 2 line x 20 character LCD screen for informational
messages about the encoder and its configuration. When first powered on, it runs through a
power on self-test sequence during which a series of messages are displayed. During normal
operation (when the self tests are complete) the encoder will cycle through a series of
messages as outlined in Table 1 below. As noted, the display is read-only and cannot be used
to set configuration parameters. The first two messages are user-configurable and can be
modified on the
the LCD display will alert you to configuration errors or warnings.
VBrick Systems
Release: x.x.x
Figure 1. Front Panel LCD (with Default Data)
Table 1 shows the sequence of messages displayed on the LCD panel. Note that on
encoder-only models, you will see messages relevant to the encoder. On decoder-only models
you will see those relevant to the decoder. On combination models you will see messages for
the encoder followed by messages for the decoder. The LCD display scrolls at the rate of one
new message every three seconds.
Tip: The first two messages in the front panel display are user-configurable and can be
modified (or hidden) on the
the Front Panel Settings topic for details.
16
> General page in VBAdmin. The backlight color of
System Configuration
System Configuration
> General page in VBAdmin. See
© 2016 VBrick Systems, Inc.