Advertisement
Available languages
Available languages
Toll-free: 1-866-827-4985 · model nos. 052-4345-2/052-6934-8
3.3 Securing Downrod Assembly
Raise the canopy.
Loosen the two downrod set screws on the
coupling (fig. 14).
Insert the downrod into the coupling. Make sure to
align the holes of these two parts.
Install the peaked pin through the aligned holes and
secure it with the clip.
Tighten the two downrod set screws on the coupling
(fig. 14).
3.4 Hanging Fan Assembly to Mounting Bracket
Carefully lift the fan assembly and place it on the
mounting bracket.
Rotate the fan assembly until the notch on the nylon
ball fits against the ridge on the mounting bracket
(fig. 15).
With the mounting bracket holding the fan assembly,
follow the wiring instructions (step 4).
4. Wiring Instructions
WARNING!
All wiring must be in accordance with national and local electrical codes,
including fire-rated construction. If you are unfamiliar with wiring, consult
a qualified electrician.
If you are not sure whether the electrical outlet box and fan are grounded,
contact a licensed electrician for advice. These parts must be grounded!
or circuit breaker box before installing, servicing or cleaning.
4.1 Installing Receiver Assembly
Remote and Receiver Pairing
Codes are set by pushing the location of the dip switches located on the transmitter and
receiver up or down. It is important that the code used for both the remote and receiver
are identical for the two devices to be able to communicate; otherwise the remote will
not be able to control the fan.
If you plan to install more than one fan then each fan will require the remote and receive to
use a unique code, or else one remote will be able to control more than one fan.
Clip
Peaked
pin
15
Mounting
bracket
Nylon ball
Screw
Advertisement
