NOMA 052-4345-2 Instruction Manual page 13

6. Blade Assembly to Motor
Remove all the blade bracket screws with
split washers from the motor bottom, through
the oval slot on the light kit (fig. 21).
Attach one blade assembly to the motor
bottom and secure with the blade bracket
screws and split washers (fig. 22).
Repeat the above procedures for the other
three blade assemblies.
7. Installing Bulb
Install one E12 candelabra bulb (60 W
maximum) into the light
socket (fig. 23).
Note: The dimmer function can not be
used if CFL bulb is used. There is
only ON/OFF function.
Caution! Your fan has an energy-saving wattage limiter. If you replace the bulbs
always below 190 W.
Light kit
23
bulb wattage is
Blade
screw