Radio Shack PRO-652 User Manual page 105

Parameter
Latch LED
keys
y to
Backlight
xt
the
Alarm
e 
ems
enter
se a
ly
Fav
e
Skywarn
indi-
stem.
EXPERT BELOW
r
Delay
hod
Delay Time
ac-
e the
AudioBoost
t.
GRP
Hit Count
is
TGRP Options
On or Off
On, Off or Flash
None, Chirp,
Hi-Lo, Alert, Ring,
2-Chirp, Fast Hi-
Lo, DTMF#
Yes or No
Yes or No
On or Off
1-250 x 100 ms
On or Off
Numeric value
Detailed Menu Reference
Description
Normally the Alert LED is active only while
the object is receiving a transmission. When
Latch is on, the Alert LED will remain lit
after the transmission is complete, unless
overridden by a subsequent object that is
also using the Alert LED.
Controls whether the backlight should be
on, off or flashing while the object is active.
Sets the Audible Alarm for the TGRP
object. When an Audible Alarm is selected,
the selected alarm will play at the begin-
ning of each transmission on the TGRP
object, or anytime the scanner stops for
activity on the TGRP object while scanning.
When On, the TGRP object is a member of
the Favorites Scan List.
When On, the CONV object is a member of
the Skywarn Scan List.
Controls whether a Delay is used to wait
for reply traffic after a transmission on the
TGRP.
Sets the amount of time (in 100 millisecond
intervals) for the wait for reply delay if Delay
is On, e.g., 20=2 seconds.
Applies a 6 dB boost to audio levels when
the object is active.
Increments each time a transmission is
received on the TGRP object. Global "Hit
Counts" must be set to ON. Press the
softkey to reset to 0.
Dflt
105