Connecting-up
5.2 Connecting the line and motor cable at the inverter
You must re-attach the connection covers in order to re-establish the touch protection of the
inverter after it has been connected up.
Connecting DC link or braking resistor
Use the rubber cable gland as shown in the right-
hand figure for connecting the braking resistor.
Using a sharp knife, cut the cap of the cable gland
corresponding to the diameter of the connection
cable of the braking resistor and establish the con-
nections.
An optional shield plate is available as strain relief
for the connection cable of the braking resistor.
The connections for the DC link have not been
released in the current version.
56
Top shield plate - FSD ... FSF (Page 106)
Hardware Installation Manual, 01/2017, A5E33294624B AE
Power Module PM240-2