Maintenance - Worx WG119E Safety And Operating Manual

Changing the line spool
Manually winding the line
OPERATION INSTRUCTIONS
1. AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a small
length of line is fed out.
A 'clattering' noise will be heard for a short time. This
is normal and is caused by the line being cut by the
line cutter. Once the line is cut to the correct length,
the 'clattering' noise will stop and the trimmer motor
will run at full speed.
To feed more line, stop the trimmer completely, then
restart, allowing the motor to reach full speed. Repeat
this until you hear the 'clattering' noise of the line
cutting. (Do not repeat this procedure more than 6 times)
2. MANUALLY FEEDING THE LINE (See Fig. G)
Press and release manual line feed button (13), whilst
gently pull out the lines until the lines reaches the
line cutter.
When the required amount of line is fed out, gently
pull on the second line (there is no need to press the
manual line feed button again). If the line extends
past the line cutter, too much line has been fed out.
12
If too much line is fed out, remove the cutting head
cover and rotate the spool anti-clockwise until the
line is at the desired length.
Removing the Cap (See Fig. H)
Press and hold in the two latches (15).
Pull the Cutting Head Cover away from the Cutting
Head. Keep the cap and spool holder clean from
debris. To replace the cap, press it firmly towards the
spool holder. Ensure that it is correctly connected
by trying to remove it without depressing the two
latches.
Changing the Line Spool (See Fig. J, K)
First take off the cap and remove the old spool. Place
new spool into cutting head. Feed one line through
the eyelet, then repeat for second line (See Fig. K).
Release line from cleat on the Spool. Reattach the
cap.
WARNING! Your Trimmer is designed to only
use line with a maximum diameter of
1.65mm. Only use nylon line.
IMPORTANT - Always wind the line onto the
upper section of the spool first.
3. MANUALLY WINDING THE LINE (See Fig. L,
M, N, O)
Take approximately 5m line and insert 15mm of
line into one of the holes in the upper section of the
spool (See Fig. L). Wind the line in the direction of the
arrows on the top of the spool (See Fig. M, N).
2-in-1 Grass Trimmer/Edger WG1 19E
Leave approximately 100mm of line unwound and place
See Fig. J, K
it into the cleat. Repeat on the lower section of spool.
Care should be taken to ensure that the line is neatly
See Fig. L, M,
coiled on the spool (See Fig. O). Failure to do so will
N, O
impair the efficiency of the automatic line feed.
Then fit the spool as described above in "Changing
the Line Spool".

MAINTENANCE

Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your lawn
trimmer. Never use water or chemical cleaners to
clean your lawn trimmer. Wipe clean with a dry cloth.
Always store your lawn trimmer in a secure, dry
place out of the reach of children. Keep the motor
ventilation slots clean. Keep all working controls
free of dust. If you see some sparks flashing in the
ventilation slots, this is normal and will not damage
your lawn trimmer. Do not place other objects on the
product.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.