4.2 Wireless AP Mode
In "Wireless AP", click "Setup Wizard" in the left column and
then click "Next". The setting methods please refer to 4.1.4 to
4.1.6.
In this mode, the device is a converter that can convert the
wireless and wired signals. You can connect a single Ethernet
cable to the access point or let it pick up another wireless device's
transmission, and make a wireless connection available to all in
range. You can also adjust the connection properties to obtain an
IP address automatically in Internet protocol.
4.3 WISP Mode
If you are provided the wired wan access by your ISP to access the
Internet, you should select WISP mode. Please follow the "Setup
Wizard" to configure the device.
4.3.1 In WISP mode, click "Setup Wizard" in the left column and
then click "Next".
24