Connecting Using The Component Video; Output; Watching Progressive Scan Video From The Component Video Outputs - Pioneer DV-393-S Operating Instructions Manual

Connecting up
Connecting using the
component video output
You can use the component video output
instead of the standard video out jack to
connect this player to your TV (or other
equipment). This should give you the best
quality picture from the three types of video
output available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
TV
P B
HDMI
OUT
COAXIAL
P R
DIGITAL AUDIO OUT COMPONENT VIDEO OUT
Watching progressive scan video
from the component video outputs
This player can output progressive scan video
from the component video output. Compared
to interlace video, progressive scan video
effectively doubles the scanning rate of the
picture, resulting in a very stable, flicker-free
image.
To set up the player for use with a progressive
scan TV, see Video Output settings on page 35.
When the player is set to output progressive
scan video, the PRGSVE indicator lights in the
front panel display.
COMPONENT
VIDEO IN
VIDEO OUT AUDIO OUT
L
R
Y
Important
• When Component Out (page 35) is set to
Progressive, there is no video output from
the VIDEO OUT (composite) jack.
• If you want to display video on more than
one monitor simultaneously, make sure
the player is set to Interlace.
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the player to progressive, you will not be
able to see any picture at all. In this case,
switch everything off and reconnect using
the supplied video cable (see Easy
connections on page 11), then switch back
to Interlace (see below).
Switching the video output to interlace
using the front panel controls
Switch the player to standby then, using the
front panel controls, press
while pressing to switch the player back to
Interlace.
• DV-490V only: If the player is connected
using HDMI, disconnect the HDMI cable
before resetting the player to interlace
output. (If left connected, the HDMI output
resolution will be reset to its default—see
Resetting the output resolution to the
default setting with HDMI connection on
page 15.)
STANDBY/ON
DV-490V
02
STANDBY/ON
13
En