580J***(D,F)
SINGLE PACKAGE ROOFTOP
GAS HEATING/ELECTRIC COOLING UNIT
TWO STAGE COOLING CAPACITY CONTROL WITH NOVATIONt COIL
SIZES 08, 12, 14 WITH PURONR (R- - 410A) REFRIGERANT
®
This product has been designed and manufactured
to meet Energy Star® criteria for energy efficiency.
However, proper refrigerant charge and proper air
flow are critical to achieve rated capacity and effi-
ciency. Installation of this product should follow all
manufacturer's refrigerant charging and air flow in-
structions. Failure to confirm proper charge and
air flow may reduce energy efficiency and short-
en equipment life.
Base Unit
S Puron (R- -410A) HFC refrigerant
S ARI certified efficiency levels up to 11.1 EER
S Rated in accordance with ARI Standard 360
S Designed in accordance with Underwriters' Laboratories Std
1995 and listed by UL and UL, Canada
S Two- -stage cooling capacity control
S Non- -corrosive composite sloping design; side or center drain
condensate pan. Meets ASHRAE Standard 62
S Standard cooling operating range from 40_F up to 115_F
(4_C up to 46_C). Field installable accessory extends the
minimum down to - -20_F (- -29_C).
S Convertible from vertical to horizontal airflow for slab mounting
S Two- -inch disposable return air filters
S Thru- -the- -bottom power and gas entry capability
S Single point gas and electric connections
S 24- -volt control circuit protected with resettable circuit breaker
and 75- -VA transformer
S Belt drive, constant torque, permanently lubricated
evaporator–fan motor
S Totally enclosed condenser motors with permanently lubricated
bearings
S Low- -pressure and high- -pressure switches
S Full perimeter base rail with built- -in rigging adapters and fork
truck slots
S Centralized Terminal Board for component and unit wiring
connections
Submittal Data
580J***(D,F) units are high- - efficiency, single- - packaged
electric cooling, gas heating units that are pre- - wired and
pre- - charged with PuronR (R- - 410A) HFC refrigerant.
Units utilize an all aluminum flat micro- - channel tube
with louvered fins condenser coil—NOVATIONt. The
units are factory tested in both heating and cooling modes.
These units meet the ASHRAE 90.1- - 2007 and Energy
Star minimum efficiency levels as well as also meeting
2010 efficiency standards.
STANDARD FEATURES
Cabinet
S Access panels with easy grip handles and NO- -STRIP screw
collar
S Pre- -painted exterior panels and primer- -coated interior panels
tested to 500 hours salt spray protection
S Fully insulated cabinet
S Tool- -less filter access door
Refrigerant System
S Acutrolt refrigerant metering system
S Liquid line filter drier
S Scroll compressors with internal line- -break overload protection
S Copper
S NOVATION all aluminum condenser coil
S Removable gauge line plugs for reading refrigerant pressure
with unit panels in place
Gas Heat
S IGC solid- -state gas heat exchanger control for on- -board
diagnostics, anti- -cycle protection, LED error code designation,
burner control logic and energy saving indoor fan motor delay
S Gas efficiencies up to 82%
S Designed in accordance with ANSI Z21.47 (design and test
standard for gas furnaces) and ANSI Z233.1 (National Fuel Gas
code relating to appliance installation requirements)
S Induced draft combustion
S Redundant gas valve, with up to 2 stages of heating
S Flame roll- -out safety protector
S Solid- -state electronic direct spark ignition system
DESCRIPTION
tube
, aluminum fin evaporator coil