Test Of The Actuators On The System - Bosch FW 200 Installation And Operating Instructions Manual

US/CA
8.10 Test of the actuators on the
system
INSTALLER SETTINGS: Output test
The Output test menu gives you the opportunity
to activate individual actuators (pumps, mixing
valves) individually to check their function.
As long as one or several actuators
are activated manually, a
corresponding message will be
shown on the display.
Stop all output tests: Use this parameter to
•
reset the activation of all actuators to Auto.
Pump, heating circuit 1:
•
– Auto: Control of the pump according to the
set program
– Manual ON: Pump always on
– Manual OFF: Pump off
Pump, heating circuit 2: See above under
•
Pump, heating circuit 1
Mixer, heating circuit 1:
•
– Auto: Control of the mixing valve according
to the set program
– Manual 100 % open: Mixing valve in open
position
– Manual 50 % open: Mixing valve in middle
position
– Manual 0 % open: Mixing valve in closed
position
Menu settings INSTALLER SETTINGS (for installers only) | 85
Mixer, heating circuit 2: See above under
•
Mixer, heating circuit 1
Tank charge pump: See above under Pump,
•
heating circuit 1
DHW recirculation pump: See above under
•
Pump, heating circuit 1
For menu structure and adjustment range
page 65.
6 720 643 256 (2010/05)