Charging The Drone - Protocol DRONIUM 3X Instruction Manual

CHARGING THE DRONE BATTERY
1. Make sure the drone is turned off.
2. Pull out the cartridge battery from the drone.
3. Connect the USB charging cable to the battery.
4. Plug the charger into a USB port. The USB light will turn off while charging
and will turn on once fully charged.
5. Plug the battery back into the drone and close the battery cover.
Charging time: 150 minutes --- Flying time: approximately 12-15 minutes
DO NOT CHARGE OVERNIGHT OR BEYOND
THE CHARGING TIME STATED. DO NOT LEAVE
BATTERY UNATTENDED.
*Battery: Li-Po, 3.7V, 1800mAh
BATTERY SIGNALS
Lights are steady
Lights slowly flash once every 2 seconds
Lights quickly flash twice every second
If you purchased extra batteries, allow the engines to cool between flights in order
to prolong engine life.
CAUTION WHEN CHARGING
1. When charging, place product on a dry, well-ventilated surface and keep
away from heat sources.
2. Always use adult supervision while charging.
3. In order to increase battery longevity, avoid repeat charging and excessive
discharging.
4. As battery temperature is high immediately after flight, charge after cooling
down for higher efficiency.
5. Do not strike or subject battery to hard impacts or sharp surfaces.
6. Do not use any other charger than that which is supplied with this item.
7. Do not use or leave battery near a heat source such as fire or space heater;
exposure to heat may result in reduced performance or in some cases
dangerous conditions.
8. If battery is left in charging state for an extended period of time after being
fully charged, the battery may automatically discharge.
9. Never leave the battery unattended during charging.
10. Do not disassemble battery.
11. Do not submerge battery in water.
Power is over 70% - will perform flips
Power is under 70% - will continue to fly
but will no longer perform flips –
approximately 8-9 minutes left of flight time
Power is under 20% - approximately
2 minutes left of flight time
5