Tower Mounting; Figure 8 Tower Mounting - ABB Tropos 6410 Installation Manual

Place the upright router onto the top of the mounting bracket, as shown in
5.
23. Secure the mounting bracket to the router by attaching two 5/16-inch machine screws
through the holes in the mounting bracket tabs to corresponding holes on the bottom of the
router.
To continue installing the router, see

Tower Mounting

You can mount the router on an outdoor tower.
Note
At the antenna level, the router must be free from metal obstruction within a 4-foot radius
FIGURE 8
Mount the Tropos router on a tower
1. Remove the pole bracket from the mounting bracket, if they are attached.
2. Make a tower bracket by attaching the mounting bracket directly to any stainless steel or
galvanized steel pipe.
Attach the mounting bracket to the tower arm so that the top of the shield is horizontal and
3.
level.
Tighten the mounting bolts.
4.
5. Place the upright router onto the top of the mounting bracket, as shown in
23. Secure the mounting bracket to the router by attaching two 5/16-inch machine screws
through the holes in the mounting bracket tabs to corresponding holes on the bottom of the
router.
To continue installing the router, see
Tropos Routers Installation Guide, Models 6410 and 6420
Tower Mounting
"Connecting Data and Power Cables"
4'
1 1/2'' minimum diameter pipe
Brackets not included
"Connecting Data and Power Cables"
Chapter 2
Figure 5 on page
on page 29.
(Figure 8).
Figure 5 on page
on page 29.
27