ABB Tropos 6410 Installation Manual page 25

Mount the router on a wood pole
Select a mounting location. You can attach the router to any outdoor wood pole of diameter
1.
at least 1 inch.
Attach the pole bracket to the pole by threading a 1/4-inch bolt through the hole in the lower
2.
clamp slot to the pole. The bolt should be at least 3 1/2 inches in length. Make sure that the
bracket is level.
3. Attach the mounting bracket of the router to the pole bracket with two 5/16-inch machine
screws (refer to
— Insert one screw through the hole at the top of the mounting bracket to the hole at the top
— Insert the other screw through the curved slot track in the mounting bracket to the hole in
4. Level the mounting bracket by rotating the unit along the curved slot tracks. Tighten the
screws.
Place the upright router onto the top of the mounting bracket, as shown in
5.
23. Secure the mounting bracket to the router by attaching two 5/16-inch machine screws
through the holes in the mounting bracket tabs to corresponding holes on the bottom of the
router.
To continue installing the router, see
Tropos Routers Installation Guide, Models 6410 and 6420
Figure 4 for the correct orientation):
of the pole bracket.
the middle of the pole bracket just above the clamp slot.
"Connecting Data and Power Cables"
Chapter 2
Figure 5 on page
on page 29.
25