Vision Fitness X6200 Assembly Manual page 6

PINK BAG
3
STEP
• Slide the rubber boot on to the
console mast.
• Unfold the wire harness located in
3
the frame bracket. Wrap the wire tie
STEP
coming from the bottom of the console
mast around the end of the wire
harness. Pull the wire tie and wire
harness up through the top of the
console mast while simultaneously
sliding the mast into the frame
bracket.
• Secure the mast to the frame using
three lock washers (M8) and three
capscrews (M8x60L). Tighten with the
6mm Allen wrench.
• Slide the rubber boot down the
console mast and snap it in place
on top of the side cover.
• Remove the four screws from the
back of the console with the Phillips
screwdriver. Connect the wire harness
to the plug in the back of the console.
Attach the console to the console mast
with the four screws removed at the
beginning of this step.
• Attach waterbottle cage.
6