Philips FC8715 Manual page 11

Hide thumbs Also See for FC8715:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Using the cleaning time button on the remote control
FC8715, FC8710, FC8700: Press the cleaning time button on the remote control to make the robot
clean for 35 minutes. When the cleaning time is finished, the robot returns to the docking station to
recharge (Fig. 34).
Using the power switch
Setting the power to 'off' position places the robot in deep sleep mode. In this mode, the robot does
not respond anymore.
- If you want to charge the robot, you need to press the power switch to 'on'.
- If the robot goes into deep sleep mode during use, you can reactivate it by setting the power
switch to 'on' and by charging the robot. After a few seconds the robot will respond again
- When you are not going to use the robot for a month or more, press the power switch to 'off' and
unplug the docking station or the adapter to protect the rechargeable battery and to save energy.
Signals and their meaning
The robot has a display with three indicators: a warning indicator, a start/stop indicator and the dust
container full indicator. The table below explains the meaning of the signals.
Signal
The start/stop indicator is on continuously.
The start/stop indicator flashes slowly.
The start/stop indicator flashes quickly.
The dust container full indicator lights up.
The warning indicator lights up.
Clap response
The clap response is enabled when the robot enters sleep mode in the following situations:
- when it stops cleaning due to an error
- when you have programmed a short cleaning time
- when it cannot find its docking station in 20 minutes
If you do not see the robot, you can locate it by clapping your hands once. The robot will respond by
beeping and by lighting up all icons on its display.
Meaning
The robot is ready to clean.
The robot is charging.
The robot is searching for the docking station.
The rechargeable battery of the robot is low.
The dust container is full.
The robot was lifted while it was cleaning.
The bumper of the robot is stuck.
A wheel or side brush is stuck.
The top cover is not present or is not closed
properly.
The robot cannot find the docking station.
English
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fc8710Fc8705Fc8700

Table of Contents