Nevco MPCW-7 Control Operator's Manual page 45

Problem
I have to set up the same segment
timer project every time I change
sports
I cannot restart a segment
The drills are fine, but we need
time to get ready for the next drill.
I cannot tell when all the segments
have expired.
The horn keeps randomly
sounding. (Hockey)
If the problem persists please contact the Nevco Service Department
Appendix
(Segment Timer)
Troubleshooting Chart
Cause
Not saved in the profile being used.
Or using the wrong profile
Not saved in any profile
No you cannot restart a segment.
Auto Advance is on
No extra segments have been set up
for time between drills.
If one cannot display segment timer
on the Scoreboard or the display is
just a timer.
IF one can display segment timer
project on the scoreboard
Interval horn is enabled
800-851-4040
40
Solution
Go to Profiles in the OPTIONS menu
and load the profile that has the segment
timer desired saved in it
Set up the timer as needed, then from the
OPTIONS Profiles menu, save a profile.
When you start the control, go to the
options menu and load the desired
profile to use.
You can change the segment's currently
displayed time. As soon as it expires, the
next segment in the list is loaded. (The
original time remains unchanged.)
Go to Edit Segment in the Segment
Timer Options and turn Auto Advance
off for the desired segment.
Set up an extra segment, for time to get
ready, for each drill.
Set up an extra segment or two at the
end of the segment list. Set these
segments to a short amount of time.
Each should have auto horn and auto
advance Enabled. The horn sound will
alert to the end of the segment timer
project
The segment number is displayed in the
Guests place on a standard scoreboard
Go to Interval horn in the options menu,
and turn off the Interval Enable option.
.