Maintaining And Cleaning The Ion Spot; Safety Regulations; Maintenance Intervals (Rule-Of-Thumb) - GLP ION.SPOT Instruction Manual

5 Maintaining and Cleaning the Ion Spot

5
The I o n S p o t is a low maintenance fixture. It is only necessary to clean the optical
I o n S p o t
LED lenses from time to time. For safe operation it is absolutely essential that the
fixture is kept clean and that dust, dirt and smoke-fluid residues must not build up on,
or within the fixture. If they do, the fixture's light-output will be significantly reduced,
and damages to the fixture may occur. Regular cleaning will not only ensure the
maximum light-output, but will also allow the fixture to operate reliably throughout its
entire life.
A soft lint-free cloth moistened with any good glass cleaning fluid is recom-
mended. Under no circumstances should alcohol or solvents be used to clean
the fixture or its lenses!

5.1 Safety regulations

• Disconnect the fixture from mains power before commencing any
maintenance work!
• Wait minimum 15 minutes after removing the power to allow the fixture to
cool down.

5.2 Maintenance Intervals (rule-of-thumb)

The maintenance schedule of any given fixture depends on the installation
environment. Hence no specific guidelines can be given. The cleaning intervals
given below are suggestions, based on practical experience. We suggest that
you start with these and develop your maintenance schedule as you see the
fixtures performance your specific environment.
Maintenance
LED reflector and optical system
Attention:
• Never let optical parts come into contact with oil or fat.
• Before running the fixture wait until all parts are touch dry.
• Never touch lenses with bare fingers.
GLP German Light Products GmbH
R - G - B
R - G - B
R - G - B
Interval
weekly
Instruction version 1.1
How
soft brush /lint-free cloth
9