About The Battery; Charge The Battery - Honeywell RP2B User Manual

•

About the Battery

Power is supplied to the printer by a rechargeable lithium ion battery. Batteries are
shipped only partially charged. The battery should be charged for a minimum of 4
hours before initial use to ensure optimal performance.
Warning: The maximum operating temperature of the printer is 122ºF
See
tery.

Charge the Battery

1. Remove the battery from the printer then remove the red battery isolator.
2. Reinstall the battery in the printer. Align the release tab with the same side as
2
Print Media
Honeywell offers a full line of applicable printing labels, receipt media, and
supplies.
(50°C), however the maximum operating temperature for
charging when used with a Honeywell power supply is limited
to 104ºF (40°C). Charge the printer in a location that meets this
temperature requirement.
Battery Charge Information
the charge contacts and lock the battery into position. The latch clicks into
on page 33 for further information about the bat-
RP2/RP4 User Guide