Download Print this page

Led Display; Audible Indicators - Honeywell RP2B User Manual

Hide thumbs


Button Press
Short press
Press and hold for 3 to 4 seconds
(when configured for continuous form
receipt paper)

LED Display

If all the LEDs are red and blinking, it indicates it is too warm or cold for the printer
to print. See
Battery charge level
Bluetooth indicator
WiFi signal

Audible Indicators

1 long beep
2 short beeps every 5 seconds
2 long beeps
3 short beeps
5 short beeps
Product Specifications
Solid green = Printer is on
Short green flash = Printer is asleep
Blinking red = Charger input voltage is too low or too high
When not charging:
Off = Battery is midway to fully charged
Solid orange = Battery charge is 10-30%
Blinking red = Battery charge is 10% or less
When charging:
Solid green = Battery charge is 90% or more
Solid red = Battery charge is less than 90%
Off = Bluetooth radio is off, disabled, not associated with a mobile
device, or printer is off
Solid blue = Bluetooth is enabled and connected
Off = WiFi radio is off, disabled, not associated with a mobile device or
network, or printer is off
White = WiFi is enabled and connected
Feeds label or paper length approximately 1 in. (2.54cm)
when configured for continuous media. Feeds media to
align with the next label when configured for gap or black
mark media.
Media feeds continuously to the maximum label length
beginning on page 41 for more information.
Power supply disconnected
No media
Power supply connected
Battery charge is low
Printer door open
RP2/RP4 User Guide

Hide quick links:



  Also See for Honeywell RP2B

  Related Manuals for Honeywell RP2B

This manual is also suitable for: