Hardware Installation - EnGenius EAP900H User Manual

Hardware Installation

1. Ensure that the computer in use has an Ethernet
Controller (RJ-45 Ethernet Port). For more information,
verify with your computer's user manual.
2. Connect one end of the Category 5e Ethernet cable into
the RJ-45 port of the EAP900H and the other end to
the RJ-45 port of the computer. Ensure that the cable
is securely connected to both the EAP900H and the
computer.
3. Connect the Power Adapter DC connector to the DC-
IN port of the EAP900H and the Power Adapter to an
available electrical outlet. Once both connections are
secure, verify the following:
a) Ensure that the POWER light is on (it will be orange).
b) Ensure that the 2.4GHz/5GHz WLAN light is on (it will
be green for 5G, blue for 2.4G).
c) Ensure that the LAN (Computer/EAP900H Connection)
light is on (it will be blue).
d) Once all three lights are on, proceed to set up the
access point using the computer.
This diagram depicts the hardware configuration.
PC
15
Ethernet
AC/DC
Cable
Power
Outlet