Case Front Control - Red-D-Arc FX360XL Operator's Manual

FX360XL

Case FrOnT COnTrOl

2
1
10
9
11
1. Thermal LED: A yellow light that comes on when an over
temperature situation occurs. Output is disabled until the
machine cools down. When cool, the light goes out and
output is enabled.
2. Amperage LCD Display
3. Voltage LCD Display
4. VRD LED indicators
5. Crosslink communication indicator – When green the power
source is connected to a feeder via crosslink
6. Hot Start Control Dial – Full range selection of hot start from
0 to 10.
7. Arc Force Control Dial: Full range selection of arc force from -
10 to +10.
8. Local/Remote Selector Toggle Switch: Sets the control of the
output to local (output control knob) or remote (K857 hand
amptrol or K870 foot amptrol through the 12-pin or
compatible wire feeders through the 14-pin circular
connectors or remote via CrossLinc™ control.).
FIGURE A.1A
13
9. Output Control Dial: Sets the Output Current or Voltage for the
selected Weld Process.
10. Weld Process Selector Switch: A rotary switch that toggles
through the 5 available weld modes for the FX360XL –
CC-SMAW; CC-GTAW; CV; CV-Innershield.
11. 3-pin
12. Power Switch: Controls input power to the Red-D-Arc
FX360LX.
13. Positive and negative welding output connections .
A-3
INSTALLATION
4
3
6
5
7
8
12