Red-D-Arc FX360XL Operator's Manual page 28

FX360XL
CrossLinc™ - CrossLinc is a new welding system communication
technology. When using a CrossLinc enabled power source such
as the FX360XL and a CrossLinc enabled wire feeder such as the
LN-25X, welding voltage can be controlled remotely without the
use of an additional control cable.
The digital meters on the LN-25X will show the pre-set values for
wire feed speed and voltage prior to welding. During welding, the
meters will show actual current and voltage present at the wire
feeder. After welding the meters will then flash the last welding
current and voltage that was present during welding for 10-
seconds after welding. If WFS or V is adjusted during this 10
second period, the meters will go back to the pre-set value.
• When a LN-25X CrossLinc enabled feeder is connected with
the FX360XL using the standard weld power cable, and the
LN-25X sense lead is attached to the work piece, the
CrossLinc light will automatically illuminate on both the
Flextec 350X and the LN-25X. No additional pairing of the
machine to the feeder is needed. This light indicates the
CrossLinc connection is active and that control of the Flextec
350X voltage can be made at the LN-25X feeder.
• The FX360XL Output Control Local/Remote switch should be
set to 'Remote' allowing for remote control of the output at
the CrossLinc equipped feeder.
B-8
OPERATION