Red-D-Arc FX360XL Operator's Manual page 26

FX360XL OPERATION
SMAW
This weld mode is a constant current (CC) mode featuring
continuous control from 15 – 425 Amps.
It is intended for the SMAW stick welding processes and arc
gouging. The mode can also be used for TIG operation without
changing modes.
Hot Start - The Hot Start control regulates the starting current at
arc initiation. Hot Start can be set to '0" and no additional current
is added at arc start. Increasing from 0 to 10 will increase the
additional current (relative to the preset current) that is added at
arc initiation.
Arc Control - The Arc Control regulates the Arc Force to adjust the
short circuit current. The minimum setting (-10) will produce a
"soft" arc and will produce minimal spatter and shallow
penetration. The maximum setting (+10) will produce a "crisp"
arc and will minimize electrode sticking with deeper penetration.
Voltage Display – This display will display three dashed lines
when the machine is in the idle state. This indicates that voltage is
not settable in this weld mode. While output is enabled, the actual
welding voltage will be displayed. After welding, the meter holds
the actual voltage value for 5 seconds. Output adjustment while in
the "hold" period results in the "prior to operation" characteristics
stated above. The displays blink indicating that the machine is in
the "Hold" period.
FIGURE B.2
B-6