Ikon IK82 Installation And User Manual page 9

Touch Button Explanation
Speed Choice : Your device has 3 speed level. Depending on the cooking and frying steam , you
should run the device with low- medium or high Speed.The device turned on with the control button
on the front panel. In the models with the electronic control there is a TIMER function.
Tımer
If you press one of the control buttons for more than 2 seconds , the LED illumination will blink for a
moment as a sign of turnin on of the TIMER. After 15 minutes the engine will stop automatically
1.Speed
Illumination
The product has 2 lamps and one lamp button to operate illumination. Press lamp button in order to
start illumination.
Usage of 3 Speed Digital Control
Peel protective papers out from the inox devices after assembly.
Speed Choice
The device has 3 degrees of ventilation. According to the cooking and frying steam, you can
choose low-middle-high ventilation levels. Buttons on the front panel are used for turning the
device on. The models with eletronic controllers have automatic timers. 15 minutes automatic
timer is turned on, when pressed any of the buttons, which starts the motor up, more than 2
seconds. When timer starts, display will signal and after 15 minutes motor will automaticly stop.
Please turn on hob and hood at the same time to activate circulation. This will provide positive
effect on vacuum power. Let the device run for a while after cooking process is finalised, thus the
remaining smell and steam will be absorbed.
2nd Speed
Illumination
The product has 2 lamps and one lamp button to operate illumination. Press lamp button in
order to start illumination.
Cleaning Periods of Aluminum Filter
Filter should be cleaned when "C" signal appears on the Display or each 2-3 weeks (in accordance
with the usage frequency). After cleaning and replacing filters to their places,
pressed for more than 3 seconds (when the product is off) in order to remove the "C" signal. "E"
signal will appear on Display and product will start working at normal position. If you want to
continue using your product without removing "C" signal, active speed will appear for 1 second
when you press
button, then "C" signal will appear once more and the motor will continue operating.
2.Speed 3.Speed Lamp
3rd Speed Lamp Button
button should be
-12-
Installing the External Chimney:
Place internal chimney into external chimney. Place
chimneys to motor box and push it downward. Make
sure that the connection between the body and motor
box is so tight.Figure 12
Installing internal chimney
Pull internal chimney upwards through the external
chimney. Fix the chimney with 3,5 x 9,5 nickel
covered screws.Figure 13
3,5 x 9,5 RYSB
Nickel Screw
After complete the installing the hood, please check all the connections before operate it.
Please take off the protective folio from you product.
External
chimney
Figure 12
Internal
chimney
Figure 13
-9-
E