Page 3
WARNINGS AND SAFETY PRECAUTIONS *This appliance is intended for home usage. that are not replaced in time may cause a risk of fire *Operating voltage of your appliance is 220-240 due to the fat collected on them. Volt~50 Hz. *Do not use filtering material that are not resistant to *A grounded plug is installed on the power cord of flames instead of filters.
Page 4
WARNINGS AND SAFETY PRECAUTIONS *In case of any fire, de-energize the hood and any when the hood installation is completed. other cooking devices, and cover the fire. Do not use *Exhaust of the hood shall not be connected to air water to put off the fire.
Vital risk, risk of poisoning! Cleaning and protective maintenance There is a vital risk of being poisoned due to the Risk of being burnt, Risk of electric combustion gases sucked back. Do not operate shock! the appliance together with the air-circulated fire Due to the appliance.
Cleaning and protective maintenance Operating modes ■ Surface may be damaged due to abrasive or You may operate this appliance with discharge air hard cleaning materials. Never use abrasive or hard mode and circulated air mode. cleaning materials. Cleaning of the appliance surface Procure the proper cleaning and protective materials Discharge air mode for your appliance from the authorized service.
Carbon Filter Installation of the Appliance Active carbon filters shall be used for filtering the Installation of the suspension plate to air inside the room and giving it back to the room the hood: in environments without a flue connection. You may There are 2 (L) shaped suspension plates available in procure the active carbon filter from your authorized the installation accessories to suspend the appliance...
Page 8
Figure 7 Suspending the Hood to the Wall: Hold the hood from its body and suspend it to the wall on A and B points using the (L) plates you have fixed on the hood cabinet before. Figure 8 Figure 4 Drill the D, E points with a Ø...
NOTE: If the hood seems skewed, adjust the alignment of the hood by loosening the M5 screws that the suspension plates on the top are installed to. Figure 11 Figure 13 Tighten the inner flue to the flue installation plate secured on the wall from its upper external sides.
Page 10
Operation Control area Variant 3 This manual applies to several appliance variants. Fan Level Timer Timer Some specifications described here may not apply Reduction Time Setting Time Setting to your appliance. Note: Turn on the hood when you start cooking and turn it off only after a few minutes later than you have finished cooking.
Filter Warning: Clean filter warning is 2- Back light option: Back light is turned on as displayed after 60 hours of operation and flashes factory default. every 1 second. You may reset the filter time and Optionally, back light may be turned off by pressing Lamba On/Off clear filter icon by pressing M on/off button for 3 V+ button for 5 seconds (a beep sounds) when the...
Lamba Simgesi: Lamp Icon: The lamp icon Control area Variant 6 on the digital screen shall be activated when you touch this icon. To activate dimmer feature, user shall hold his/her finger pressed on the lamp icon as in the other products.
Before Contacting Authorized Dealer • Ensure that the appliance is plugged in the outlet and that the fuses are OK. If the Lighting Does Not Operate: • Ensure that the appliance is plugged in the outlet and that the fuses are OK. Figure 16 •...