Table of Contents
Advertisement
Installing Plastic Outlet
Install plastic outlet to top of motor cabin via 3,5x9,5 screws
(Figure 4).
3,5 x 9,5 RYSB
Screws
Drilling Mounting Holes
Attach mounting schemeon the wall and drill holes on points
marked as A,B,C via Ø8 mm driller. To install chimney part, use
Ø6 mm driller by taking reference of min./max. height
dimensions .
WARNING : During drilling the hanging holes , please pay attention to the diameter of the
holes to be used for hanging the hood.
If the diameters of hanging holes are not as pointed , the hood can not be assembled properly.
Nailing Dowels
Nail Ø10 mm dowels into A,B,C holes drilled as Ø8 mm.
Place Ø6 mm dowels on two holes, drilled as Ø6 mm
(Figure 5)
3120-3170 models / for 80-90cm models, drill holes on
points marked as G,H and nail Ø10 mm dowels into it.
Figure 4
Ø 8 mm
Ø 6 mm
Outlet Connection
Holes
Ø 6 mm
Hood Hanging
Holes
Ø 8 mm
10 mm Plastic
6 mm Plastic
dowel
dowel
-6-
PROGRAMMABLE OPTIONS
Programmable options can be set when motor and lamp is closed and not set.
1-Back light brightness settings: When – button is pushed for approximately 5 seconds blue
color percentage appears on the screen (for example: b 00). When V- button is pushed once more
red color percentage will appear on the screen. (for example: r100) When V- button is pushed
once more green color percentage will appear on the screen. (for example: g10). Pressing Tmr+
and Tmr- buttons (pressing for longer time it can be set fast) the color whose percentage appears
on the screen can be set between 0 and 100. New color is set pressing – button for 5 seconds
(beep sound is heard) and settings mode will be left. In order to leave settings mode without
setting an option, on/off or lamp buttons can be pushed.
2-Back light option: Back light is always at on position. Keeping + button pressed for 5 seconds
(beep sound will be heard) when motor and lamp is off and not set (that is when the chimney hood
is not operating) back light can be set so that it will be off. In order to set back light to be on
constantly + button should be pressed for approximately 5 seconds.
Blue (%)
D
E
TECHNICAL SPECIFICATIONS
A
Feeding Voltage
B
Motor Isolation Class
G
C
Isolation Class
H
Figure 5
Red (%)
Green (%)
Light Turquoise
Light Green
Green
Blue
Purple
Red
Colourless screen
Orange
220-240 V 50Hz
F
CLASS I
-15-
Color
Advertisement
Table of Contents
