Ikon IK82 Installation And User Manual page 10

Replacing the Lamps
Cut off the connection of the cooker hood with electricity. Take off the aluminum cassette filter. Take
off the failed lamp and replace it with a new one that is of the same rating. (Please wait for the lamps
to cool as they might hurt your hand.)
Replacing 50W Halogen Lamp
In order to change halogen lamps, take the lamp downwards
pushing back of lamp holder downwards and then turning it a
little bit anti-clockwise take it off downwards. Figure 14
Replacing 20 W Lamps
In order to replace halogen lamps, hold one lamp, as shown in
and turn it to left tor right. Bring the lamp pin in the same line
with socket and pull towards yourself.Remove glass cover as
shown in Picture with an object, which would not scratch
product's surface . To remove pull the faulty lamp down, and
replace with a new one. Figure 15
Replacing bulb
In order to change the bulb, turn it anti-clockwise and take it off.
Replace it with a new one in the same value by turning it in
clockwise. Figure 16
Functions of the Product
Your hood is compatible for use with our without chimney.
Usage with chimney
The product should be connected to a chimney that will direct the air out during usage with chimney. In
order to achieve best performance, pay attention that the duct system follows the shortest way for
connection to the chimney. Your product is produced as it will be appropriate for usage with chimney.
Attention!!!
Outlet of the product should not be connected to air canals that have other smoke as well.
Active Carbon Filter
To provide air recirculation where product's chimney air outlet cannot be connected to exterior, it
is necessary to use active carbon filter with your product. You may purchase this accessory from
authorized sellers and after sales services
Figure 14
Figure 15
Figure 16
-10-
Carbon Filter Usage
Your product is compatible with two types of carbon filters.
You may see following information on how to use carbon filters.
Before installing or replacing carbon filter, first you should cut your product's power off.Carbon
filters should be replaced with a new one each 3-5 months because it is used at kitchens that does
not have chimney outlet.
Carbon filter should never be washed.
Grease filters should be installed on the product even when carbon filter is not in use. Do not use
your product without grease filter.
Replacing Carbon Filter
It is necessary to install 2 carbon filters to your product.
To place the carbon filter, place your filter on connection channels on motor and turn it
clockwise.In order to remove filter, turn it anti-clockwise. Figure 17
Figure 17
Changing Aluminum Cassette Carbon Filter
In order to take the carbon filter off, pull it towards yourself holding the upper latch. Figure 18
Figure 18
-11-