Ikon IK82 Installation And User Manual page 5

Usage of 3 Speed Digital Control
Peel protective papers out from the inox devices after assembly.
Speed Choice
The device has 3 degrees of ventilation. According to the cooking and frying steam, you can
choose low-middle-high ventilation levels. Buttons on the front panel are used for turning the
device on. The models with eletronic controllers have automatic timers. 15 minutes automatic
timer is turned on, when pressed any of the buttons, which starts the motor up, more than 2
seconds. When timer starts, display will signal and after 15 minutes motor will automaticly stop.
Please turn on hob and hood at the same time to activate circulation. This will provide positive
effect on vacuum power. Let the device run for a while after cooking process is finalised, thus the
remaining smell and steam will be absorbed.
2nd Speed
Illumination
The product has 2 lamps and one lamp button to operate illumination. Press lamp button in
order to start illumination.
Cleaning Periods of Aluminum Filter
Filter should be cleaned when "C" signal appears on the Display or each 2-3 weeks (in accordance
with the usage frequency). After cleaning and replacing filters to their places,
pressed for more than 3 seconds (when the product is off) in order to remove the "C" signal. "E"
signal will appear on Display and product will start working at normal position. If you want to
continue using your product without removing "C" signal, active speed will appear for 1 second
when you press
button, then "C" signal will appear once more and the motor will continue operating.
3rd Speed
Lamp Button
button should be
-16-
Standard Accessories
Plastic Outlet (Figure 1)
Plastic outlet mounted to air outlet of the cooker hood
Place of the Product:
After installation of your product, distance between
range hood and electrical hob should be at least 65
cm and gas hobs at least 75cm. Figure 2
Installation, taking off your product from its package:
*Check if there is any deformation on your product.
*Transportation damages and failures should immediately be reported to the transportation
responsible.
*If you notice any damage please report to the seller.
*Do not allow children to play with packing material!!!
Installing Hanging Bar
There are 2 L shaped hanging bars in to install your product,
provided with screws. Fix bars on product body via M5 x 35
screws into M5 turn screws (Figure 3).
M5 x 35 Ysb Hanging bar
Screws
Figure 1
Min.65 cm
Min.75 cm
Figure 2
Figure 3
-5-