Ikon IK82 Installation And User Manual page 8

Tighten the Hanging Screws:
Fix product onto wall from point C with 5,5x60 Ysb screw in
order to ensure your product is safely installed. Figure 9
3120-3170 models / for 80-90cm models;
Fix product onto wall from point G,H with 5,5x60 screws
in order to ensure your product is safely installed. Figure 10
Installing Aluminum Flexible Pipe:
Connect aluminum flexible pipe to outlets on the product and
kitchen wall.
Please make sure that this connection is strong enough not
to break when the hood is on in the highest level. Figure 11
C
Figure 9
G - H
Figure 10
Figure 11
-8-
Usage of 5 Speed Digital Control
Usage
Remove protective folio on the inox product after installation.
Speed Selection The product has 5 speeds of ventilation level. One of 1,2,3,4,5 speeds is
selected in accordance with steam of cooking or fry. Motor is started pressing
on the front panel. Speed is increased pressing
Automatic timer (TIMER) is available at the models with electronic remote control. When you press
C
button more than 2 seconds, timer function will be on for 15 minutes. When the timer is on,
Display will signal and the motor will be off automatically 15 minutes later. Please use the cooker
and the product at the same time to enable circulation. Doing so, air suction power will be affected
positively. We recommend you to operate your product for few minutes more after the cooking is
completed to enable absorption rest of smell and steam.
Illumination
The product has 2 lamps and one lamp button to operate illumination. Press lamp button in
order to start illumination.
Cleaning Periods of the Aluminum Filters:
Filters should be cleaned when C signal appears on Display or (according to usage) each 2-3
weeks. In order to remove C signal, after the filters are cleaned and replaced to their place, press
button more than 3 seconds (when the product is at off position). Letter "E" will appear on
Display and the product will operate as normal. If you would like to continue using the product
without deleting C signal, when you press the
1 second, then C signal will appear once more and the motor will continue operating.
NOTE: C signal will appear after usage of the product for 60 hours.
control button
button, and decreased by pressing
button active speed will appear for
-13-
button.