Sony BVM-1916 Operation And Maintenance Manual page 43

To specify the system in which D-1 signals are to be
received
Before starting the following procedure, set DJ OPTION of the above
OPTION INSTALLATION menu I to YES.
1
Move the cursor with then button to DI CONFIGURATION on
the MONITOR CONFIGURATION menu and press the ENT
button.
The DI CONFIGURATION menu is displayed.
D1 CONFIGURATION
a
PAL
NTSC
SECAM
SPECIFY SETTING OF LOCAL
SWITCH ON BV BOARD
SELECT AND PRESS ENT
The asterisk indicates the current setting.
2
Move the cursor with the n button to the system matching setting
of the local switch on the BV board.
3
Press the ENT button.
The message "DAT A SAVED" is momentarily displayed and the
monitor returns to normal status.
To set the setup level for component signals
1
Move the cursor with then button to COMPONENT OFFSET on
the MONITOR CONFIGURAITON menu and press the ENT
button.
The COMPONENT OFFSET menu is displayed.
COMPONENT OFFSET
·N-10/SMPTE
BETACAM 0
BETACAM 7.5
SELECT AND PRESS ENT
The asterisk indicates the current setting.
2
Move the cursor with the n button to the appropriate setup level.
N-10/SMPTE: When supplying the 100/0/100/0 component
signals.
BETACAM 0: When supplying the 100/0/7S/0 component
signals.
BETACAM 7.5: When supplying the I00/7.5/75/7.5 component
signals.
1. Operation
11
-39