Sony BVM-1916 Operation And Maintenance Manual page 40

Section 1 Operation
1-361 '·
Operation
5
Move the cursor with the~ button to the pin whose assignment is
to be changed, then press the ENT button.
The following message appears.
CONFIG PARALLEL REMOTE
PLEASE SELECT FUNCTION
TO BE APPLIED TO PIN
AND PRESS ENT
6
Press the button on the front panel or in the drawer (listed on page
1-34) whose function is to be assigned to the pin selected in step 5.
7
Press the ENT button.
Repeat steps 5, 6 and 7 for the other pins as desired.
8
When the pin assignment is completed, move the cursor to SA VE
AND APPLY and press the ENT button.
The massage "DATA SAVED" is momentarily displayed, and the
monitor returns to normal status.
9
Press the LOCAL/REMOTE button to set the monitor to the
remote control mode.
To cancel the operation
Press the ESC button before pressing the ENT button in step 8.
IU§iii
• When the INPUT selector 2, 3 or 4 is assigned to one of the
REMOTE connector pins through CONFIGURE PARALLEL, the
input signal for the assigned INPUT selector is selected by short-
circuiting the pin to GND. In open status, the input signal of the
INPUT selector 1 is selected.
• When two or more INPUT selectors are assigned to the REMOTE
connector pins, be sure not to simultaneously short-circuit these pins
toGND.