Connecting Using The Component Video Output; Connecting Auxiliary Components - Pioneer S-EV1000V Operating Instructions Manual

02 Connecting up
Connecting using the component
video output
If your TV has component video inputs, you can
use these instead of the standard or S-Video
output to connect this system to your TV.
should give you the best quality picture from
the three types of video output available.
• Use a component video cable to connect
the COMPONENT VIDEO OUT to a set of
component inputs on your TV.
L
IN
R
LINE
VIDEO
OUT
P
R
S VIDEO
About progressive scan video
Compared to interlace video, progressive scan
video effectively doubles the scanning rate of
the picture, resulting in a very stable, flicker-
free image. Progressive scan video is available
only from the component video output.
Important
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the system to progressive, you will not be
able to see any picture at all. In this case,
STANDBY/ON to put the system
press
in standby, then press and hold the front
Note
1 The component video output is switchable between interlaced and progressive formats. See Video Output settings on page 44.
2 Consumers should note that not all high-definition television sets are fully compatible with this product and may cause arti-
facts to be displayed in the picture. In case of 525 progressive scan picture problems, it is recommended that the user switch
the connection to the 'standard definition' output (Interlace). If there are questions regarding our TV set compatibility with this
model, please contact our customer service center.
12
En
COMPONENT
INPUT
L
CUT
R
COMPONENT
VIDEO OUT
Y
P
B
OUT
panel
until the display shows MEM.CLR?. Press
the front panel
the display shows INTERL?. Press the front
panel
1
This
switch the system back on.
Compatibility of this player with
progressive-scan and high-definition TVs.
This player is compatible with progressive
video Macro Vision System Copy Guard.
This system is compatible with the following
Pioneer displays and monitors: PDP-505HDG,
PDP-435HDG, PDP-5040HD, PDP4340HD,
PDP-502MX, PDP-503HDG, PDP-504HDG,
PDP-433HDG, PDP-434HDG, SD-532HD5,
SD533HD5.

Connecting auxiliary components

This system has both stereo analog inputs and
outputs. Use these to connect external
components, such as a VCR, MD, CD-R or DAT
recorder.
• Connect the LINE IN jacks on the rear
panel to an auxiliary playback component.
These include components such as a VCR,
DAT, or your TV. Connect using RCA pin-plug
stereo cables.
• Connect the LINE OUT jacks on the rear
panel to a recording component.
These include components such as a cassette
deck, VCR, MD recorder, or another recorder
with analog inputs. Connect using RCA pin-
plug stereo cables.
(stop) button for about 7 seconds
or button so that
button to set to interlace and
2