Table of Contents
Advertisement
Audio Adjustments
Adjusting loudness
Loudness compensates for deficiencies in the
low and high sound ranges at low volume.
1
Press AUDIO to select LOUD.
Press AUDIO until LOUD appears in the dis
play.
2
Press a to turn loudness on.
LOUD :ON appears in the display.
3
Press b to turn loudness off.
LOUD :OFF appears in the display.
Note
You can also turn loudness on or off by pressing
LOUD.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off. When a sub
woofer is controlled with this unit, first, switch
the RCA output setting to subwoofer, then
turn the subwoofer output on. For more de
tails, see Switching the RCA output setting on
page 37.
1
Press AUDIO to select SUB.W.
Press AUDIO until SUB.W appears in the dis
play.
# When the RCA output setting is RCA :S/W,
you can select SUB.W.
2
Press a to turn subwoofer output on.
SUB.W :ON appears in the display. Subwoofer
output is now on.
# To turn subwoofer output off, press b.
3
Press c or d to select the phase of sub-
woofer output.
Press c to select reverse phase and
PHASE :REV is displayed. Press d to select
normal phase and PHASE :NOR is displayed.
Adjusting subwoofer (low pass
filter) settings
When the subwoofer output is on, you can ad
just the cut off frequency and the output level
of the subwoofer.
1
Press AUDIO to select 80Hz.
Press AUDIO until 80Hz appears in the dis
play.
# When the subwoofer output is on, you can se
lect 80Hz.
# If the subwoofer setting has been previously
adjusted, the frequency of that previously se
lected will be displayed instead of 80Hz.
2
Press c or d to select cut-off frequency.
Each press of c or d selects cut off frequen
cies in the following order:
506380100125 (Hz)
Only frequencies lower than those in the se
lected range are output from the subwoofer.
3
Press a or b to adjust the output level
of the subwoofer.
Each press of a or b increases or decreases
the level of the subwoofer. +6 24 is dis
played as the level is increased or decreased.
Adjusting low pass filter
attenuation slope
When the subwoofer output is on, you can ad
just the continuity of sound between speaker
units.
Section
08
29
En
Hide quick links:
Advertisement
Table of Contents
