Tips And Assistance; Questions And Answers; Accessories And Spare Parts; Authorizations (Testo 770-3 Only) - TESTO 770 Instruction Manual

11 Authorizations (testo 770-3 only)

10 Tips and assistance

10.1. Questions and answers

Question
OL
dISC
(testo 770-3 only)
OPEn
If we have not been able to answer your question, please contact
your dealer or Testo Customer Service.

10.2. Accessories and spare parts

Probe and other assemblies are appropriately rated for measurement
category III or IV and have a suitable voltage rating for the circuit to be
measured.
11 Authorizations (testo 770-3 only)
Please note the following country-specific information for the product
authorization.
Pos: 37 /TD/Zulassungen/Daten_testo 770 @ 18\mod_1443699524993_0.docx @ 222392 @ 5555555551 @ 1
European Certification
Belgium (BE), Bulgaria (BG), Denmark (DK), Germany (DE), Estonia (EE),
Finland (FI), France (FR), Greece (GR), Ireland (IE), Italy (IT), Latvia (LV),
Lithuania (LT), Luxembourg (LU), Malta (MT), Netherlands (NL), Austria
(AT), Poland (PL), Portugal (PT), Rumania (RO), Sweden (SE), Slowakia
(SK), Slowenia (SI), Spain (ES), Czech Republic (CZ), Hungary (HU),
United Kingdom (GB), Republic of Cypres (CY).
EFTA countries
Iceland, Liechtenstein, Norway and Switzerland.
Other countries
USA, Canada, Australia, Turkey
USA
FCC ID: WAF-2016T770-3
Information from the FCC (Federal Communications Commission)
For your own safety
Shielded cables should be used for a composite interface. This is
to ensure continued protection against radio frequency
interference.
FCC warning statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
24
Possible causes/solution
The reading exceeds the measuring range upper limit
> Check input value and change if necessary.
The capacitor to be tested still contains charge.
> Discharge capacitor properly and carry out the test
again.
No connection to the probe tips during the RCDC
measuring mode.
> Establish a connection to the measurement object.