JLG 600A Operation And Safety Manual page 61

If equipped with Soft Touch, the switch
enables the functions that were cut out
by the Soft Touch system to operate
again at creep speed, allowing the
operator to move the platform away from the obstacle that
caused the shutdown situation.
If equipped with SkyGuard, the switch
enables functions cut out by the Sky-
guard system to be operated again,
allowing the operator to resume use of
machine functions.
If equipped with both Soft Touch and
SkyGuard, the switch operates like
described above and allows the opera-
tor to override the system that has
experienced a cutout situation.
14. Tower Telescope
This switch provides for extending and retract-
ing of the tower boom when positioned to in
or out. Tower Telescope must be fully retracted
before operating Tower Lift. (Tower Telescope should not
function when Tower Lift is not fully elevated "up").
3121615
SECTION 3 - MACHINE CONTROLS AND INDICATORS
TO AVOID UPSET AND SERIOUS INJURY, DO NOT OPERATE MACHINE IF TOWER LIFT
AND TELESCOPE DO NOT OPERATE IN THE ORDER DESCRIBED ABOVE.
15. Tower Lift
This switch provides for raising and lowering of
the tower boom when positioned to "up" or
"down". Tower Lift must be fully elevated "up"
before operating Tower Telescope. (Tower Lift should not
function when Tower Telescope is extended).
16. Soft Touch/SkyGuard Indicator (If Equipped)
Indicates the Soft Touch bumper is against an object or the
SkyGuard sensor has been activated. All controls are cut out
until the override button is pushed. For Soft Touch, controls
are then active in the Creep Mode or for SkyGuard, controls
will work normally.
17. Platform Rotate
Provides rotation of the platform when posi-
tioned to the right or left.
– JLG Lift – 3-17