Section 2 - Disassembly And Reassembly; Special Tools - Polaroid Spectra/Image One Board Repair Manual

Sectiion 2 - Disassembly and Reassembly
Note: This section presents only the One Board Spectra Pro/Image Pro/Minolta Pro
camera disassembly and reassembly procedures that are different from those of
the Spectra camera. See Spectra Service Manual for all disassembly and
reassembly procedures not covered here.

Special Tools

Special Tools for Disassembly
• Hinge Pin Removal/Insertion Tool
P/N 13384 (for grasping Mid-Cover Hings Pins; See Figure 2-1)
• Square Socket Tool Bit with Handle
P/N 11913 (for removing screws holding LCD Board to Ranging Board;
see Figure 209)
Warning: Do not use the torque-limiting screwdriver to remove these screws.
Special Tools for Reassembly
• Torque-Limiting Screwdriver
P/N CR13397, with special Square Bit, P/N CR 13398 (for installing screws holding
LCD Board to Ranging Board; See Figure 2-9)
• Solder AideTool (green/black stick) P/N 942268
• Long needle-nose pliers with coated jaws
P/N 13186 (for reassembly of wire connectors use them to position the wire
connector with the pin connector, then use the Solder Aide Tool to press into position)
Warning: Do not use these pliers for disassembly.
9