Table of Contents
Advertisement
Setup
Part names and
functions
A
Microphone
LED indicator
MHIGHN/MLOWN
Used to change the sensor
sensitivity (page 17).
Rear cover
M
N
Used to confirm the status of the
sensor or register the sensor to
the hub.
LED indicator
You can press M
LED indicator to confirm the sensor's
status. After confirming the sensor's
status, we recommend turning the LED
indicator off by pressing M
as soon as possible, otherwise battery
life may be reduced.
8
B
C
E
N and check the
N again
Indicator
Green, lit
Red, lit
Red,
blinking
Green,
blinking
slowly
Off
Note:
R The LED indicator does not indicate
sensor status if the sensor has not
D
been registered (page 10).
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the batteries
The sensor is battery powered.
3
Registration
Required only if the sensor was
purchased separately (i.e., not as
part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5
Installation
Install the sensor in the desired
location.
Status
No glass break
detected
Glass break was
detected
Sensor is out of range
of the hub
Registration mode
(You pressed and held
M
N)
No battery power
Advertisement
Table of Contents
