Philips 247E3LHSU2/00 Service Manual page 103

Vsync
Composite sync TTL level, input impedance 2.2k ohm terminate (Positive/Negative) Sync on green
video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
2). DVI-D Digital
Input signal: Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)
3) HDMI ( option , refer to Quick specification table) Follow HDMI 1.4 specification
TMDS channel:
Carries audio, video and auxiliary data.
Signaling method: According to DVI 1.0 specification. Single-link (Type A HDMI).
Video pixel rate: 25 MHz to 165 MHz (Type A)
Pixel encodings: RGB 4:4:4, YCbCr 4:2:2, YCbCr 4:4:4.
Audio sample rates: 32 kHz, 44.1 kHz, 48 kHz
Audio channels: 2.
DDC channel:
Allows source to interrogate capabilities of sink.
I²C signaling with 100 kHz clock.
E-EDID data structure according to EIA/CEA-861D and VESA Enhanced EDID.
Content protection:
According to High-Definition Content Protection (HDCP) Specification 1.10.
HDMI video input should support timing defined in CEA 861-D specification with extended EDID
blocks
Video timing support:
Format
480p
576p
720p
1080i
1080p
Picture centering -
Over Scan -
1. RGB signal:
2. YUV signal:
(But only 1080p define is OFF )
PC timing: to follow PC timing table
TMDS/+5V/DDC/HPD/CEC Signals
(TMDS Signal)
Termination Supply Voltage AV
Differential Voltage Level:
Positive/Negative
Resolution Type
720 x 480 SD
720 x 576 SD
1280 x 720 HD
1920 x 1080 HD
1920 x 1080 HD
H & V 0.5 %. (for TV, 480i/p, 576i/p, 720p, 1080i/p)
OFF (no this function)
(Video timming) ON (Be use and set ON/OFF)
: 3.3V±5%
CC
150mV – 1200mV
Vertical frequency
60Hz
50Hz
50Hz , 60Hz
50Hz , 60Hz
50Hz, 60Hz
Meridian 3 103