Lower the power board assembly to remove the wiring from the hooks
shown by the arrows.
Position it as shown in the figure.
Remove the wiring from the hook.
To remove the protection from the connectors:
disconnect the hooks securing it on one side
and on the other.
Remove the connectors.
When reassembling:
Repeat these steps in the reverse order.
Insert the earth wire of the power supply cable beneath the hook and wrap
it and arrange it as shown in the figure.
15.2.2 Solenoid valve
See page 68.
15.2.3 Display board assembly
See page 68.
95/104
Technical Support - MDM
599 77 39-16 Rev. 00