14.4.4 Tub suspension springs
Left spring
Attach the spring as shown in the figure: the shortest leg faces towards
the side, whereas the longest leg faces towards the welded tub.
Right spring
The instructions provided for the left spring also apply to the right spring.
When reattaching the springs (after repair work which required their removal), make sure that the
bushings shown in the figure are featured on both ends (the colour of the bushings in the photos
below may vary).
Pay attention to the differences between the bushings (see enlarged details).
Spare bushings are available, under the following codes:
Upper bushing code 405 50 62-51/9
Lower bushing code 405 50 62-52/7
Apply some grease on either end of the spring. Use grease
code 5026 24 16-00/6
Technical Support - MDM
83/104
599 77 39-16 Rev. 00